Edge CTS Manual de usuario descargar pdf (Pagina 11)

HARDWARE INSTALLATIONS

11

Installation Instructions

EAS

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

TABLE OF CONTENTS INTRODUCTION HARDWARE INSTALLATIONS MYSTYLE SOFTWARE

EDGE SENSOR INSTALLATION

This section gives step-by-step

instructions on how to install

either the Edge Temperature

Sensor and/or the Edge Pressure

Sensors.

TEMPERATURE SENSOR

PARTS INCLUDED:

(1) Temperature Sensor

(1) Temperature Wire Harness

REQUIRED TOOLS:

-3/8” socket/wrench

-1/2” socket/wrench

-1/8”-27 NPT Thread Tap

-21/64” Drill bit

-Drill

-Thread Sealing Compound

PRESSURE SENSORS

PARTS INCLUDED:

(1) Pressure Sensor

(1) Pressure Wire Harness

REQUIRED TOOLS:

-13mm Wrench/Socket

-1/8”-27 NPT Thread Tap

-21/64” Drill bit

-Drill

-Thread Sealing Compound

NOTE: Edge has provided

adapters that are speciﬁ c to the

temperature and pressure sen-

sors. The two non-terminated

wire adapters (Shown in Fig-

ure 10) included in the main

kit are not needed at this time.

They can be set aside for any

future sensor installations.

NOTE: First install the Main

EAS Cable Assembly accord-

ing to the instructions located

on pages 5 and 6 then continue

with the following steps.

Both sensor installs require a

hole to be drilled and tapped.

Follow these instructions to

properly create the hole:

1) Find the best location for the

sensor. Figure 11 (on the next

page) gives a basic example of

the temperature sensor being

installed to the side plate of a

manual transmission. This loca-

tion is ideal for this particular

install because the plate can

easily be removed, modiﬁ ed,

and reinstalled without get-

ting any metal ﬁ lings inside the

transmission.)

NOTE: The wall of the object

you will be drilling into needs

to be thick enough to properly

capture the sensor’s threads.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comentarios a estos manuales

Sin comentarios